You are here

  • § 325.1
    Scope of the rules in this part.
  • § 325.3
    Effective date.
  • § 325.5
    Definitions.
  • § 325.7
    Allowable noise levels.
  • § 325.9
    Measurement tolerances.
  • § 325.11
    Issuance, amendment, and revocation of the rules in this part.
  • § 325.13
    Inspection and examination of motor vehicles.
  • § 325.21
    Scope of the rules in this subpart.
  • § 325.23
    Type of measurement systems which may be used.
  • § 325.25
    Calibration of measurement systems.
  • § 325.27
    Use of a windscreen.
  • § 325.31
    Scope of the rules in this subpart.
  • § 325.33
    Site characteristics; highway operations.
  • § 325.35
    Ambient conditions; highway operations.
  • § 325.37
    Location and operation of sound level measurement system; highway operations.
  • § 325.39
    Measurement procedure; highway operations.
  • § 325.51
    Scope of the rules in this subpart.
  • § 325.53
    Site characteristics; stationary test.
  • § 325.55
    Ambient conditions; stationary test.
  • § 325.57
    Location and operation of sound level measurement systems; stationary test.
  • § 325.59
    Measurement procedure; stationary test.
  • § 325.71
    Scope of the rules in this subpart.
  • § 325.73
    Microphone distance correction factors.
  • § 325.75
    Ground surface correction factors.
  • § 325.77
    Computation of open site requirements—nonstandard sites.
  • § 325.79
    Application of correction factors.
  • § 325.91
    Exhaust systems.
  • § 325.93
    Tires.

Part 325
COMPLIANCE WITH INTERSTATE MOTOR CARRIER NOISE EMISSION STANDARDS

§ 325.35: Ambient conditions; highway operations.

(a)(1) Sound. The ambient A-weighted sound level at the microphone location point shall be measured, in the absence of motor vehicle noise emanating from within the clear zone, with fast meter response using a sound level measurement system that conforms to the rules of § 325.23.
(2) The measured ambient level must be 10 dB(A) or more below that level specified in § 325.7, Table 1, which corresponds to the maximum permissible sound level reading which is applicable at the test site at the time of testing.
(b) Wind. The wind velocity at the test shall be measured at the beginning of each series of noise measurements and at intervals of 5-15 minutes thereafter until it has been established that the wind velocity is essentially constant. Once this fact has been established, wind velocity measurements may be made at intervals of once every hour. Noise measurements may only be made if the measured wind velocity is 12 mph (19.3 kph) or less. Gust wind measurements of up to 20 mph (33.2 kph) are allowed.
(c) Precipitation. Measurements are prohibited under any condition of precipitation, however, measurements may be made with snow on the ground. The ground surface within the measurement area must be free of standing water.

Citation: [40 FR 42437, Sept. 12, 1975, as amended at 41 FR 10227, Mar. 10, 1976; 41 FR 28267, July 9, 1976]