You are here

  • § 325.1
    Scope of the rules in this part.
  • § 325.3
    Effective date.
  • § 325.5
    Definitions.
  • § 325.7
    Allowable noise levels.
  • § 325.9
    Measurement tolerances.
  • § 325.11
    Issuance, amendment, and revocation of the rules in this part.
  • § 325.13
    Inspection and examination of motor vehicles.
  • § 325.21
    Scope of the rules in this subpart.
  • § 325.23
    Type of measurement systems which may be used.
  • § 325.25
    Calibration of measurement systems.
  • § 325.27
    Use of a windscreen.
  • § 325.31
    Scope of the rules in this subpart.
  • § 325.33
    Site characteristics; highway operations.
  • § 325.35
    Ambient conditions; highway operations.
  • § 325.37
    Location and operation of sound level measurement system; highway operations.
  • § 325.39
    Measurement procedure; highway operations.
  • § 325.51
    Scope of the rules in this subpart.
  • § 325.53
    Site characteristics; stationary test.
  • § 325.55
    Ambient conditions; stationary test.
  • § 325.57
    Location and operation of sound level measurement systems; stationary test.
  • § 325.59
    Measurement procedure; stationary test.
  • § 325.71
    Scope of the rules in this subpart.
  • § 325.73
    Microphone distance correction factors.
  • § 325.75
    Ground surface correction factors.
  • § 325.77
    Computation of open site requirements—nonstandard sites.
  • § 325.79
    Application of correction factors.
  • § 325.91
    Exhaust systems.
  • § 325.93
    Tires.

Part 325
COMPLIANCE WITH INTERSTATE MOTOR CARRIER NOISE EMISSION STANDARDS

§ 325.23: Type of measurement systems which may be used.

The sound level measurement system must meet or exceed the requirements of American National Standard Specification for Sound Level Meters (ANSI S1.4-1971), approved April 27, 1971, issued by the American National Standards Institute, throughout the applicable frequency range for either:
(a) A Type 1 sound level meter;
(b) A Type 2 sound level meter; or
(c) A Type S sound level meter which has—
(1) A weighing frequency response;
(2) Fast dynamic characteristics of its indicating instrument; and
(3) A relative response level tolerance consistent with those of either a Type 1 or Type 2 sound level meter, as specified in section 3.2 of ANSI S1.4-1971.


Disclaimer:

Although we make every effort to assure that the information we provide is complete and accurate, it is not intended to take the place of published agency regulations. Regulations issued by the U.S. Department of Transportation and its Operating Administrations are published in the Federal Register and compiled in the U.S. Code of Federal Regulations (CFR). Copies of appropriate volumes of the CFR in book format may be purchased from the Superintendent of Documents, U.S. Government Printing Office, or examined at many libraries.

The CFR may also be viewed online at http://ECFR.gpoaccess.gov.